Start block HW config

Interfacing to the codebug
Post Reply
Posts: 67
Joined: Sat Aug 15, 2015 1:41 pm

Start block HW config

Post by pigraham »

Roger James wrote:I would like to set all four legs as inputs with pull ups.. But Blocky will a). not let me set a pullup on leg 1, and b). Only allows 7 entries in the config block..

I havent got a clue on how to raise bugs on this site. Where are the support links? ... s-blockly/
PiGraham wrote:Full compliment of config blocks on start.
start.png (7.11 KiB) Viewed 5138 times
You can't control pullup on leg 1. Presumably it's hard-wired. 1 does not appear in the leg number dropdown.
Legs default to input so no need to set in/out except where you want to set to output. ... kly-remix/
Posts: 1
Joined: Thu Oct 15, 2015 5:32 pm

Re: Start block HW config

Post by rogerjames99 »

Hi Graham,

Thanks for the remix. If had come to that conclusion myself also. It is a pity that there is so little documentation available.
My next step is to switch to the python interface and see what the behaviour is there. Without schematics it is difficult to see if the absence of a pullup means a pulldown or a floater. I will stick the scope on and see.

Post Reply